Required Update Order | Driver Sets
NUC Bundle Guide > 2. Support Information > 2.3 Supported BIOS, Firmware, & Drivers
After identifying your NUC version and platform use the following table to determine the correct drivers. The details listed below are currently supported by Logitech and Intel. Using a driver that is newer or older than the current one listed may cause issues. Updates to the NUC are only pushed down from Windows Update if there is a security update required.
Required Update Order
Note: You must update the BIOS of Tiger canyon in order. Do not go to the latest version in a single update. If you do not go in this order, your Tiger Canyon Nuc will become unusable.
The update order is:
- 69
- 71 (REQUIRED before updating to 73)
- 73 (Currently Supported)
- 74 (NOT SUPPORTED)
You can download the firmware updates here:
Platform |
BIOS Version |
Windows Installable |
BIOS |
UEFI |
Release Notes |
Recovery |
Tiger Canyon (NUC11TKNi5 REV2+) |
69 |
|
||||
Tiger Canyon (NUC11TKNi5 REV2+) |
71 |
|||||
Tiger Canyon (NUC11TKNi5 REV2+) |
73 |
|||||
Tiger Canyon (NUC11TKNi5 REV2+) |
74 (NOT SUPPORTED) |
TNTGL357.0074.EBU.EXE (NOT SUPPORTED) |
TN0074.CAP (NOT SUPPORTED) |
TNTGL357.0074.UEFI.zip (NOT SUPPORTED) |
TN_0074_ReleaseNotes.pdf (NOT SUPPORTED) |
TNTGL357.0074.RECOVERY.zip (NOT SUPPORTED) |
Bean Canyon (NUC815BEH REV1, No Label) |
89 |
Intel’s’ instructions on how to update BIOS: https://gtm.vc.logitech.com/Intel/BIOS/NUC-AptioV-UEFI-Firmware-BIOS-Update-Readme.pdf
Driver Sets
You can download the latest version of the driver sets here.
Microsoft Teams Room on Windows, Tiger Canyon and Bean Canyon, Windows 11 IoT
- Download Here (1.4GB)
Zoom room on Windows, Tiger Canyon and Bean Canyon, Windows 10 LTSC:
- Download Here (1.9GB)
You can use the built in Windows tool PNPUtil to inject the updated drivers or use SCCM or any other system management tool to update drivers:
PNPUtil.exe /add-driver:<path to folder>\*.inf /subdirs /install
For example:
1. Create a directory c:\Drivers.
2. Extract the downloaded drivers to that directory.
3. You should now have a directory c:\Drivers with several folders under it.
4. Open a command prompt as admin.
5. Run the below command.
PNPUtil.exe /add-driver c:\<path to folder>\*.inf /subdirs /install
or
PNPUtil.exe /add-driver <drive>:\<path to folder>\*.inf /subdirs /install
6. You may see errors that the driver is already installed or not required, that is expected.
7. You will not receive any confirm prompts– the driver will or will not get installed.
8. At the end, the final message will tell you if the computer needs to be rebooted.
Back to Top | Next Article: 2.4 Zoom Release Notes